Flexible Skirting Board - Self Adhesive Skirting Trim - Flexible Skirting PVC Angle - White - 5m Long

Used for beading load of rubbish

Arrived quite quickly but it's not good, not very flexible, it's thick and the adhesive is not strong enough to hold it, will not stay in place or stick at corners

15m Roll - was wide enough to cover the variable gaps ( not perpendicular walls! ) Was quite tought to bend into angle but a good firm pressure sorts it! Tho slight word of warning - bending too much causes stress along the crease and couple of times it ripped along the crease . Adhesion was excellent- almost too good ( make sure surfaces are clean , free of dust , grease etc) - but caveat is the adhesive strip doesnt reach the edges so need to make sure the strip is stretched to the max before pressing for adhesion- the material is thick enough to hold it straight against the wall. Overall very pleased with result but I suggest work out a working technique with a few short trial & error runs. Mine was to press the edging strip into shape tight against the wall first & then only removing the backing paper from one the sides ,(decide which side you want to stick down first - mine was the floor half ) as you slide along in short distances. Then when done the length then remove the backing paper from & stick down the other side. This technique worked really well.

Used this instead of quadrant on a wood floor to cover the gap. Initially this was very easy to fit so long as you took some time with outer and inner corners which needed overlapping after carefully measuring and cutting. Seemed to stick very well. However after a week or so a lot of the adhesion was lost and I had to use some tinned adhesive to relay a lot of this. Now looks really good and am pleased even though extra work was required.

Worked well for mw BUT I had the sense to reinforce with stong adhesive floor spray. Wasn't an expensive extra and one canister lasts.Take your time, pre bend it and spray the surface you want to attach it too. Press along and apply pressure for good result

Bought it to cover up some rough edges on polystyrene ceiling tiles. Seemed to be cheaper option than half round self adhesive stuff which I would have preferred look wise. Basically in places it is not sticking well and will have to redo with some proper glue. The glue is a bit puny. At first I thought that when it was stuck that would be it for my ceiling tiles and if I wanted to take it off it would be wrecking them. No worries there because it's parting company. Yes I know it's for wall/floor but from what I can see the same thing will happen. Would not recommend. 2 stars.

This is a poir product total waste of money not as wide as expected to cover skirting bord down to the floor and within ten minutes of applying it was peeling away

Used for skirting