POWERTEC 70124 Universal Dust Port, 2-1/2"

Perfect. Unfortunately, delivered to the wrong address. Got it from neighbor later

Works well, fits Ridgid shop vac hose

Great add to dust box on my table saw!

I was building a cantilevered shelf on a rolling workbench that used to be a bathroom vanity that I was going to place my compact table saw on so it has a place to sit and use comfortably. I used to keep it on a shelf and take it out and use it on the floor of my garage when needed. I keep my power tools in my third bay and try to keep it as neat as possible finding a place to keep all the equipment. On the other side of the bench was going to be a table top extension that could be dropped down when not needed. My intent was to hook it up to a standard 2.5 wet vac hose. This fits my hose on an old rigid 12 gal / 5hp wet vac. I drilled a hole and dropped this into it and sealed it with some silicone caulk which I had laying around. This set up really takes care of saw dust from the table saw when in use. Not every single particle is sucked up but very close and is certainly not the products fault. Piece is sturdy plastic and should outlast me.

I needed this dust port for a down draft table I had been wanting to build. It arrived today and figured I'd go ahead and build it. Didn't want it too large,so I settled on a 24x15 size with 4.5 inch leftover pine and pegboard. Made the frame , installed 2 baffles out of leftover hardboard and cut out a 2.5 inch hole for the dust port. Hooked it up to my 16 gallon shop vac and it works great. It does hook up to a standard shop vac hose if you are wondering with no modifications needed. I've got less than $10 invested in the dust port and a couple of bucks in the leftover wood I used. Couldn't be happier

A good product but I needed to drill new holes to match my port… not a big issue.

Just what I needed for dust collection on a home made router fence. My shop vac host fits snugly, won't fall out. Does the job perfectly. I was a little worried about breaking the mounting holes at first, but just don't crank down on the screws and it's fine.

Nice product at a reasonable price

Exactly what I needed for homemade router table.

Quality is as expected. Easier than printing one in ABS. Works totally fine.

El material se ve de buena calidad, así como los acabados. Hasta el momento ha funcionado bien

Perfect fit for my router table

Use this as dust collector for my Rigid oscillating sander as the original dust port is quite ineffective. This product works just fine installed via plywood brace I made and located at the end of the belt. Connected to a small shop vac, it makes a huge difference in the amount of dust left on the table and in the air.