RFID Power Supply Door Access Control System Kit with 280kg 620LB Electric Magnetic Lock 110-240V AC to 12v DC 3A 36w

It's a great starter kit at a bargain price. This was my first experience with electromagnetic door locks. The instructions are pretty good, and the steps pretty straight forward but with no screen programming is strictly on the keypad using their flow chart.MY ONLY GRIPE is that the RFID sensor is NOT where its indicated on the control panel. It is in fact right above the #2 on the keypad. Poor labeling, but functionality it still works. Not enough to take a full star off.Additionally, the only thing the kit is missing to make it code compliant is the REX (request to exit) sensor. I added one of these mounted to the wall above my setup and it's triggered the same way the button push is. The included power supply is also enough to run the Rex which made installation easy.My advise is setup the whole system on a work bench and test it all out first. To best optimize cable runs and lengths. I used a spool of alarm wire and it works great. I added a second push to exit button under the reception desk to allow people to be buzzed in.For the price it's a great setup. I would recommend it and use it again in a future project.

Overall good, everything works the key cards and fibs were all programmed and the instructions got it working but there’s a information deficiency in the provided instructions. Only three of the 12 wires ( 5 if you connect a bell ) are used leaving some features nonfunctional or unused without better documented instructions.Such as how to set so that a card swipe AND pin pad entry are required for entry and the functions of the other unused wires are left a mystery I searched for a document page but there’s many iterations of this hardware and they don’t all have the same user procedure to program or default codesAlso you’ll need 12 volt wire and angle brackets or z bracket with additional hardware to install on a door it’s not included.

Great product with most every item you need for a lost cost door or gate entry system. This was a renewed or open box item and all parts were present. I purchased this product to replace almost the same unit that as gifted to me. The system lasted me for years with most of the parts exposed to the elements. The reason I purchased the whole system was mainly to replace the keypad which on my older unit had delaminated. if placed in a plastic housing would have lasted longer. I recommend mounting your power supply in a waterproof or resistant enclosure as well as mounting the keypad in a semi-enclosed housing. I would definitely buy this product again. The only things you will need is wiring for the components and power or an electrical plug for the power supply and wire nuts. Instruction are included.

Was wondering why there were negative reviews on this product. Once it is installed, it works like a charm. It does requires much work to get it installed properly and the spacing between the steel bar and the magnetic coil is very tight or the bar will not get attached. After several adjustments, got it to work as well as the control keypad and fob access.Modified a waterproof 2 gangs electrical outlets to hold the keypad and it works good having the keypad external to the door. The reason for 4 stars instead of 5 is I couldn't get the release button to increase the opening time though, it is defaulted to 3 seconds and it is a pain to have such a short time intervals without having the ability to increase the opening duration.

1) No instructions. 2) wire from ground on controller was missing. 3) After completing wiring and installation (upon entering code) keypad controller would greenlights (door was supposes to unlock) but about 70% of the time magnetic lock wouldn't release (I had to grind out bolt on outside of door to get into locked space). 4) Fixed it all with a 1 Gang wireless WIFI relay switch to turn off power to door and unlock the magnetic lock.This is a great lock idea if it worked. The magnetic portion of this setup works great!