Techflex 1/4 Inch Flexo Clean Cut Braided Cable Sleeve - Black - 10 Feet

For years I've been taking my guitar synth rig (GR-33) to gigs which required laying four cables from the foot controller to the amp or PA. I tried wire ties - too sharp and cut my hands. I settled for taping them together with electrical tape every foot or so. I called the bundle the beast. FINALLY, I found this product. I was able to slip all four cables into it - three 1/4" hi-impedance (guitar) cables and one power connector - without taking the ends off. The product expands to 400% its size. It took a few minutes to figure out how to do this easily as the webbing acts like a Chinese finger puzzle. Once the cables were covered, I slipped 3/4" shrink tube over the ends to hold down fraying and shrank them down tight. Even when used carefully, this product DOES fray on the ends once cut. Shrink tube handles this problem perfectly and professionally. I no longer call my little bundle of cables the beast. Highly recommended.

I purchased this to make installation of a new amp and speakers in my car more clean. My plan was to keep the factory head unit and ran the speaker outputs to the amp. Since we're talking about 4 pairs of 16-gauge wire I wanted some kind of sleeve to make the bundle easier to deal with and easier to hide. This product was easy to measure and cut, and singeing the cut end, as recommended in the included notes, worked wonderfully to prevent fraying. I bought way more length than I needed for this project but the price was right. I'd definitely buy this again.

The quality is fine but the seller sent only 8’ instead of 10’. Check the length before installing.

I bought this to protect a wiring loom I put together. It contains 3 mic cables with XLR connectors.This material is a little narrow for my application. I installed it AFTER I assembled my cables. In hindsight, I should have obtained this material before I installed the XLR connectors.But, with a little patience, I was able to work this material over the completed cable, ends and all. It was a chore but I eventually got it. I love that it's tight around the cables.I basically used this in the manner of a product known as "Pedal Python". They have a great product and it's fairly priced.

I've used 1inch and 2 inch Techflix sleeving at work and decided to use it in my house. Once I received the 1/2" sleeving I thought, "There's no way this is going to hold 2 coax cables and 5 speaker wires!" I was wrong! The sleeving opens up and then moves down the cables like a snake eating it's dinner. The process that I thought was going to take forever (if it was even going to work) took about 10mins. Now I have a single black cable running the length of the wall instead of 7 cables. Very clean, very easy to use!

This does the job but what is disappointing is that if you cut it then it starts to unravel. When I bought it I was holping that it would be the kind that isn’t a complete circle and that closes in on itself. I’ll be in the lookout for that instead of this.

As described

I had 3 25' 3.5mm to RCA cables that needed to make a long journey from my HTPC to my surround sound amplifier. I hated the idea of each one dangling out by itself, or having to stuff a bunch of cable all over, not my style. So after labeling each end, i took a ~15' length of 1/2" outer diameter PVC pipe, compressed this sleeve and put it around the PVC pipe. This then let me shove all the cables down the pipe, one end after the other. Next all it took was to pull the PVC pipe back out, leaving the braided sleeve exactly where i wanted it to be. Two black zip ties on the ends to keep it there finished it off.This product is cost effective after scouring the internet, this price was the best after shipping (free prime!) is added into the equation. Thanks, Techflex, fantastic stuff here.