185mm x 80T TCT Saw Blade x 30mm Bore. Fits Evolution Bosch Makita Ryobi Dewalt Circular Saws etc. 185mm Circular Saw Blade For Fine Cuts + 25mm/20mm/16mm Bore Reduction Rings, Fits 190mm Circular Saw

Purchased this to cut some solid core laminate bathroom worktop.Contractor had done one cut and it was rubbish, so got shot of them and recut myself with this blade. Did a cracking job. Took my time setting up for the cut and results looked really good.For the money this is a great blade

This is a cheap blade, which is perfect for plywood. The high tooth count gives a much cleaner cut than low-tooth-count blades. The tips do not stay sharp as long as a higher priced blade, but this is good enough for a big project. I built a 5m by 3m shed with a single blade, and that was about as much as it was good for.I would recommend however, by beware this is a cheaper blade, that will not last as long as better ones might.I have bought this twice, so it must be good enough.

Easy to install and cut very cleanly

I purchased this blade to cut 19mm OSB hoarding I was using to line the walls of my new steel workshop. The 24 tooth blade which was on my saw was leaving very rough cuts so I went for this 80 tooth blade in the hope it would perform better without costing the earth.At a cost of £9.57 and free delivery I was a bit wary as to what the quality would be like but I decided to go ahead and make a purchase anyway as I would try it out on some scrap wood before using it for the work in hand.In the event I needn't have worried as this blade left beautifully cut edges requiring very little effort, no burning of the wood and it was still cutting just as keenly on the last of the numerous cuts I had to make.I would highly recommend this blade to anyone as it does a great job without costing a fortune and it was also delivered very rapidly to my address.

Bought this to cut down hi gloss end panels when changing my kitchen. The cut on high gloss cabinets was factory clean and I'm very happy I bought this product.

I used it laminated kitchen work top and kitchen cabinet door, all edges is chipping and not fine edge and I used 6 speed settings... I don't know if I set the right speed....

Used for counter tops, slight burn marks but cut good if not forced.

Very good

EN EL TERCER, CORTE EMPIEZA A OLER A MADERA CALIENTE, A APARTIR DE AHI VA AMENOS. NO VALE NI PARA BRICOLAJE. NO PUEDO PONER MENOS ESTRELLAS.