Hornady Lock n' Load AP Bullet Feeder Die

Purchased 3 of these dies (9mm,40sw,45acp) to mount in my Lee Loadmaster. These dies functioned perfectly using the Bully Adapter. Plated and FMJ bullets feed well. Was able to get powder coated bullets to feed part of the time, but not well enough to operate the press in an efficient manner.

The Hornady LnL AP bullet feeder die works flawlessly! It allows me to speed up my reloading process! It also comes with a powder through case expander bushing that will allow you to free up a station on your press. PLUS..Its covered by Hornady's lifetime warranty!

The bullet feeder works great it took awhile to get it adjusted to where the bullet would feed down every time. It saves time and saves on fingers being pinched. Would like to see insruction manuals included with dies. Can't wait till hornady comes out with dies for the.223 and other rifle bullets.

This die is both ingenious and simple at the same time. The install is very easy, then adjust so if empty or has a powder load, the top shaft is clear. However, if you did a double load it would make you aware because the white doughnut is now in sight on the shaft. Not completely foolproof you just need to glance at die as the powder drop happens.

this would get 5 stars but it needed cleaned, bebured to be used. it does work great once set up. its built solid for years of use. it can be feed by hand by dropping the bullets in the top, it holds nine or so. i use the ridged plastic tube from my lee bullet feeder which holds 25 plus bullets. it was a little hard to set up because of lack of instructions.

If your Reloading (even on some other brand press) this make bullet placement a breeze. I just use a PVC tube, fill it with 100 bullets, then I run out of primers when I run out of bullets..this frees up one task so I can concentate more on others....

Add a 2 foot piece of 1/2" CPVC, and a 1/2 to 3/4" adapter and you have a bullet feeder for less than $30.00. You will have to ream the 3/4" end if the adapter out to make it fit over the die. For a 45 cal die you won't need the adapter the 1/2" CPVC tubing fits in the top of the die. The 2' tubing will hold 50 + bullets and will stand unsupported. It takes about the same time to load the bullets in the feeder as it takes to load the primers.

...it won't feed my full jacketed 155gr. bullets. I followed the instructions to the letter and no go. I watched a couple of Youtube videos as well and I have done everything right. There is something inside the collets, keeping it from easily feeding the bullets. I did notice that the gaps inside each collet are sharp and edgy. Maybe taking a buff wheel on the Dremmel or case tumbling them for a bit may help. Will contact Hornady. I need this because the RCBS die is garbage and they quit making them! If anyone else has had this issue, please reach out. Thanks