Brushed House Number 7 Seven-20.5cm 8.1in-Made of Solid 304 Stainless Steel ，Floating Appearance，Easy to Install

Very pleased with this. It is just the right size to be seen on my wall from the road. well made and easy to fit

Very well made and easy to fit, my house number is single so price not to bad but if yours is double it does work out expensive, i'm pleased with the product and would recommend,

Great looking product, I bought a 6 and a 1. They have a nice finish and feel quite solid and weighty. The way the screw screws into the back of the number is a bit lose. I also didn’t like having to hit the front of the numbers with a hammer to get them to go in the plug fully. It does tell you to cover the number so as not to scratch it but I was worried I would dint it. Took some force to get it in. I do wish if people send you wall plugs they’d be labelled so you know what size drill end to use. Not all of us instinctively know. Although I bought them knowing they were floating I did think they were stuck out too far from the wall in the dark. The numbers are positioned near a wall light and as they were stood out so much one number was casting a shadow across the other and didn’t look right. I think there was just too much shadow cast full stop. In the end I took them down, drilled longer holes , used longer plugs and reduced the amount they stood out from the wall. They now look much better at night. Having said that I like them. They give a house a modern clean look.

Number is cut precisely for a sharp finish. It could be easy to distort the number if your holes are not drilled in the perfect place. Also use a piece of timber to hit the number fixings into the wall plugs so not to damage the face of the number.

Simple to install and looks great for the money.

Fitting these should be easy. An 8mm masonry drill, to a depth of 50mm or so should work fine. Drilling a pilot hole of 4mm or 5mm first makes it easier too. Holes need to be 175mm apart, at least for this size. However, I had two house numbers, and of the 4 fixing screws supplied, 3 were OK, but 1 would not screw in. After closer examination, I realised that the thread wasn't a thread, just a series of grooves! Ended up cutting the head off an M5 bolt and filing it to a point, to make a replacement. Apart from that potential show-stopper, OK in the end.

Nice quality contemporary product. Relatively easy to fit, nice & bold yet at the same time discreet. Really sets off the new aluminium windows & front door. Hope it weather's well & looks as good in a year's time.

Really easy to install. Use rubber mallet when knocking them in.Beatiful brushed steel effect.