FG-15025 Wheel Arch Molding - Matte Black (02-R)

Like other reviewers said, you need some significant heat to make this work. That being said, it is extremely easy to form to whatever shape you need once it’s hot. I used a blowtorch to heat up my surface and then a heat gun to bend the trim as I went; cut the trim with a utility knife for the edges as needed. Adhesion seems great so far but just installed it so time will tell.

So far so good, holding up after a week. Make sure to heat it up with a hair dryer or heat gun in order to bend around the fender. Get some very strong and sharp shears to cut else the edges will be jagged. There was enough for 4 tires and 5ft left over for a 5th if you mess up.

Easy install. Quality product. Looks great

Great for fender protection..it has a lip that makes easy to apply..and if u use a heat gun it's so simple...I would love it if I could come with a special tool to cut the edges..I used a blade but not the finished I would love to

Worked great

Used this to hide rust spots. Material is very thick, stiff. You'll need a heat gun to manipulate it to the contours. The adhesive seems to be quite strong, only time will tell on durability. So far, 5 stars.. Will update after the winter months.

Just installed the Dawn Enterprises 15025 wheel well trim on my 2008 GMC 2500 HD. As a tip warm the trim with a hair dryer and have an extra person assist by removing the adhesive binding tape as you shape the molding to the wheel well. Use the adhesive promoter (especially on colder body metal). Very impressed with the results. Trim looks factory OEM. Would highly recommend this product.

This was the perfect product for my 2018 Nissan NV2500. There is a small lip that you use to go around the wheel opening, and it fits perfect. The trick is to have someone pulling the tape strips off while you are applying them and it should come out great. There was enough material to do all four wheel openings and had about 4 feet left.