Taiss 10pcs SPDT Mini Toggle Switch 3-Pin 2 Position ON/ON Miniature Toggle Switches 6A 125V AC MTS-102

As described

Great price. Worked great. Used it in a Halloween costume. Held up find and easy to use

If you're looking for garbage e-waste, they've got you covered. They arrived in a basic plastic zipper bag and only 8 switches were included instead of the advertised 10. That alone tells you something about the quality control (or lack thereof). It gets worse. I soldered 28 AWG stranded copper wire using Sn60/Pb40 rosin core solder with a temperature controlled iron set to 325°C, which is completely normal for electronics work. As soon as I finished soldering and gave the wire a light tug, the brass terminal pulled straight out of the switch body. The plastic housing clearly cannot handle normal soldering temperatures and does not properly secure the terminals. I tried a second switch and had the exact same failure. These are cheaply made and not suitable for any project where reliability matters. If you need dependable mini toggle switches, look elsewhere. I'll be returning them. I sure miss the old radio shack!

Good quality, positive feel. Worked great.

I don't know what their endurance limit is over many cycles, but they feel solid. I bolt them to my circuit boards as shown in the photo. First cut a small copper clad board only one inch by one-half inch or so. Drill three holes spaced to accept the terminals, then two more holes to accept 10 x 24 screws near the edges. With your hand grinder's cut-off wheel, cut lines in the copper to leave three lands around the terminals. Etching is not necessary. Wire, solder, and then thread tap for the two screws. Great for bread boards.

I might have seen the review about the melting switches. I am no novice with soldering, yet find it very hard to get a firm solder, without melting the switch. The plastic it is made of has a very low melting point. I burned out two of these, despite being very careful. I am getting 2.8mm female spade pins and will use those, rather than soldering. I need exactly this kind of switch, except one that DOES NOT MELT so I might get more (duh!) but then using those spade connectors instead of soldering. I think we just need to get used to the quality generally decreasing on many products. Sure, they have also become cheaper, but there is often a reason and here is one.

No issues so far!

Be careful soldering leads or you'll end up with a puddle of plastic or a nonfunctional switch.

Diligent et polis ! Merci !

Para el espacio pequeño donde los necesitaba funcionan muy bien

As the headline says; the item description and picture suggests you will get ten switches. The bag came with only one switch